Wear resistant POM Color Masterbatch
Self-lubricating wear-resistant POM masterbatch with PTFE/silicone modification. For high-wear mechanical components.
Our wear resistant POM color masterbatch incorporates self-lubricating additives for reduced friction and enhanced wear performance. Ideal for bearings, sliding components, and high-cycle mechanical parts.
Product Features
- Enhanced wear resistance
- Self-lubricating
- Low coefficient of friction
- Good dimensional stability
Typical Applications
Typical Physical Properties
Physical parameters source: internal testing data submitted by manufacturers for inspection. Values are typical and may vary by color and grade.
Physical Properties
| Project | Condition | Value | Unit | Test Method |
|---|---|---|---|---|
| Carrier Resin | — | POM (Wear Resistant) | — | — |
| Density | 23°C | 1.42–1.48 | g/cm³ | ISO 1183 |
| Melt Flow Index | 190°C/2.16kg | 5–12 | g/10min | ISO 1133 |
| Pigment Loading | — | 20–50 | % | — |
Processing Conditions
| Project | Condition | Value | Unit | Test Method |
|---|---|---|---|---|
| Processing Temperature | — | 180–220 | °C | — |
| Drying Temperature | — | 80–90 | °C | — |
| Drying Time | — | 3–4 | h | — |
| Addition Ratio | — | 1–3 | % | — |
Color Performance
| Project | Condition | Value | Unit | Test Method |
|---|---|---|---|---|
| Color Fastness | Xenon lamp 300h | Grade 4 | — | ISO 105-B02 |
| Heat Resistance | 200°C/5min | ΔE ≤ 1.0 | — | Internal |
| Dynamic Friction | vs Steel | ≤ 0.15 | — | ASTM D1894 |
Physical parameters source: Non national third-party testing certification submitted by manufacturers for inspection. Actual values may vary depending on specific color formulation, processing conditions, and application requirements. For detailed technical data sheets (TDS), please contact us.
